This high quality, weatherproof, commercial grade, digital motion detector is designed to be configured with many of the lighting systems that we offer. It is a 12 volt sensor with a fully adjustable detection from 33' to 114' (11,000 square feet). It has a coverage area of 90 degrees, 114' x 97' max. Its many features include customised optics, user/installer programming, temperature compensation, adjustable pulse count (sensitivity) settings etc. This component is designed for use with a solar energy system only and not for use with any other system or application.
Fresnel Lens with 36 zones and white light filter.
Dual axis allows lens adjustment up to 180 degree pan and up to 90 degree tilt.
Lens sections can be masked (if required) with masking foil supplied.
Customised Optics with double silicon shielded dual element (50,000 Lux reduction ability)
UV stabilized translucent outer cover.
Output # 1 is a voltage free relay with timer, selectable normally open/closed, rated to 24v dc @ 50mA, relay timer period adjustable from 04. to 60 seconds.
Output # 4 is open collector negative switching, 25mA max, relay timer period is +60 seconds, adjustable Lux settings from 2 Lux (dusk) to 24 hour (day).
Anti-tamper switch with optional and programmable output.
Automatic temperature compensation with digital sensitivity adjustment.
Digital ASIC/microprocessor control with non volatile memory.
Walk test option with LED indication.
Typical operating temperature is -4 deg. F to 131 deg. F (-20 deg. C to 55 deg. C).
Conformally coated electronics for increased stability and reliability.
Housing is made from high impact ABS.
IP55 protection rating.
Dimensions are approx. 4" x 4" x 3.5" (10cm x 10cm x 9cm).
Weight is approx. 5 ounces (145 grams).
Typical mounting height is approx. 10' (3 meters).
Made in Great Britain.
Surface mount to almost any vertical surface.
Recommended mounting height is approx. 10' (3 meters).
One year warranty*.
Additionally, unlimited, lifetime technical support is available for all warranty registrations.
Please Note: This product is a special order and is non-returnable except in the event of a fault (during its warranty period) when the product, once returned will be repaired or replaced.
The solar panel must be installed in a location where it can receive full direct sunshine (when available) and usually set facing South at an appropriate angle (where adjustment options allow). The solar panel must not be installed in a shaded or part shaded location and never indoors. The standard specifications of the system (particularly the solar panel Wattage and battery capacity) may need to be adjusted. These components are determined by your geographic location, power consumption (LED Wattage) and the total amount of hours of illumination time required. Such changes to the standard specifications may increase or decrease the cost shown. Please contact us for more information or assistance. The illumination time is estimated and subject to various factors including (but not limited to) geographic location, seasons, temperature, weather conditions & location of product etc. The illumination time of most solar lights can reduce during winter months when the weather is poor and the days are shorter. During this time insolation hours decrease accordingly. Shorter illumination time due to one or more of the above factors does not define the product as being ‘defective’ or ‘not as described’. All solar lights must be used in a completely dark location at night time otherwise they may not illuminate. Nearby strong lighting sources or ambient lighting may affect the operation of a solar light. This does not define the product as being 'defective' or 'not as described'. Please note, if you do not install or use this product for several months the battery may discharge naturally on its own. By allowing a battery to deep discharge it may cause irreversible damage as the battery may then lose the ability to recharge or hold a full charge. Although unlikely, we reserve the right to supply this product with any minor alterations or minor changes to the specifications (shown above by text description or by photographs) due to different supplies or product batches received, incorporating such product changes made by the manufacturer, without further notice. Descriptions, specifications and photographs are updated regularly but may not be current when minor changes to a product have only recently been made.
* View our Terms, Conditions and Polices (including our Returns Policy) for further information.