This mini bollard light stands approx. 17.5" tall and can be installed on to any solid level surface. It is an accent light that will spread a low level of light in the area that it's installed. It will automatically activate at dusk in "dim mode" and will switch to full brightness when motion is detected.
This solar powered mini bollard light is fitted with several warm white LEDs which produce 200 Lumens at full brightness. The light is fitted with a motion sensor which switches the light from "dim mode" to full brightness when motion is detected. The bollard stands approx. 17.5" tall, with a base approximately 6" wide. All aluminum construction with a four sided polycarbonate lampshade. The light automatically activates at dusk and will typically operate until dawn. A quality solar panel is discreetly installed on the top of the lamp post. Installation is simple and full instructions are enclosed with the product. Color of light output is warm white. Color of product is gray.
Perfect for decks, patios, driveways, pathways etc. or anywhere where you need a taller sized outdoor decorative light.
Typically illuminates dusk to dawn.
Automatic activation at dusk.
Light switches from "dim mode" to full brightness via motion sensor.
Light output is 200 Lumens.
The light output is equal to approx. 25 Watts of incandescent lighting.
Designed for accent and decorative light use.
32 warm white LEDs.
Built in motion sensor.
Aluminum body construction.
Clear polycarbonate lamp sahde.
Complete fixture stands approximately 17.5" (44cm) high.
Lampshade is approx. 6.5” (16.5cm) wide and approximately 7.5" (19cm) tall.
The base is approximately 6” (15cm) wide and has four pre-drilled holes enabling fixing.
Lithium rechargeable battery inclued and pre-installed.
Integrated 1.6 Watt high quality solar panel.
Base to be fixed to a flat, solid surface using four screws and anchors or four bolts.
Install light so that it will have full direct sun light.
One year warranty*.
Additionally, unlimited, lifetime technical support is available for all warranty registrations.
30 day 'no hassle' returns (refund or exchange on new, unused/uninstalled products)*.
The solar panel must be installed in a location where it can receive full direct sunshine (when available) and usually set facing South at an appropriate angle (where adjustment options allow). The solar panel must not be installed in a shaded or part shaded location and never indoors. The standard specifications of the system (particularly the solar panel Wattage and battery capacity) may need to be adjusted. These components are determined by your geographic location, power consumption (LED Wattage) and the total amount of hours of illumination time required. Such changes to the standard specifications may increase or decrease the cost shown. Please contact us for more information or assistance. The illumination time is estimated and subject to various factors including (but not limited to) geographic location, seasons, temperature, weather conditions & location of product etc. The illumination time of most solar lights can reduce during winter months when the weather is poor and the days are shorter. During this time insolation hours decrease accordingly. Shorter illumination time due to one or more of the above factors does not define the product as being ‘defective’ or ‘not as described’. All solar lights must be used in a completely dark location at night time otherwise they may not illuminate. Nearby strong lighting sources or ambient lighting may affect the operation of a solar light. This does not define the product as being 'defective' or 'not as described'. Please note, if you do not install or use this product for several months the battery may discharge naturally on its own. By allowing a battery to deep discharge it may cause irreversible damage as the battery may then lose the ability to recharge or hold a full charge. Although unlikely, we reserve the right to supply this product with any minor alterations or minor changes to the specifications (shown above by text description or by photographs) due to different supplies or product batches received, incorporating such product changes made by the manufacturer, without further notice. Descriptions, specifications and photographs are updated regularly but may not be current when minor changes to a product have only recently been made.
* View our Terms, Conditions and Polices (including our Returns Policy) for further information.